Sunday, August 25, 2013

Blue Moon, August 20, 2013


The full moon that rose Tuesday, August 20, 2013 was not just a Blue Moon — it's also the Full Sturgeon Moon, the Full Red Moon, the Green Corn Moon and the Grain Moon.  See the Space.com explanation of why this only full moon of August qualifies.

camera: Nikon D800
lens: AF Nikkor 180mm f/2.8 D
exposure: manual, ISO 500 @ f/8 @ 1/1000s 
support: hand held
processing: moon and sky filter simulated in Nik Silver Efex Pro 2


Saturday, August 24, 2013

Twelve Camera Memory Card Care Tips


For all memory cards, there is a limit to how many times files can be written and erased.  Memory card experts recommend these best practices that can prolong the life of a card.

Date Your Memory Cards

Memory cards have a limited life span.  Expect a heavily used card to last about six years.  A seldom used card can function about ten years.  By tracking the card’s in service date, you can replace the card before it goes bad.

Erase Pictures by Formatting the Card in the Camera

Formatting is less wear and tear than individual file deletion because only writes to the file allocation table.  If you let image import programs like Lightroom delete files after transfer, the individual file deletion shortens card life because the of the .

Don’t Completely Fill a Card

Because most camera file formats, including RAW, have some compression and therefore size variability based on subject matter, even the best cameras can’t predict exactly how many shots will fit on a card.  One shot too many with a full buffer can write over the card headers and make it unreadable.  To avoid problems, the general recommendation is to swap out cards when the camera shows 10-15 shots remaining.

Switch Camera Off Before Inserting or Removing a Card

This is in every camera manual, but it bears repeating.  Make sure the file writing L.E.D. is not lit or blinking and turn you camera off before ejecting the memory card.  Turning the camera off flushes the file writing buffer.  If a card is ejected mid file transfer, the file system can be damaged.  It also cuts off current to the card, which avoids a possible card killing voltage spike as the card ejects.  The same care applies to card readers.  Make sure you explicitly eject the card before removing it.

Rotate Your Cards

Most of us have a number of cards.  Rotating the cards spreads out the wear.  This tip applies to camera batteries, too.

Avoid Static Charges When Handling Memory Cards

Try to ground yourself before touching a card.    

Avoid Environmental Extremes

Cameras and cards are rated for certain max and min temperatures operating ranges, which should be observed.  Powerful magnetic sources and x-rays can damage cards.  If you’re traveling, the walk-through machines probably OK, but the stronger x-rays used to examine checked baggage can ruin a card.

Keep an Eye on the Camera Battery

If a camera battery voltage drops below specification or the battery goes dead with files still in the buffer, card corruption is likely.  Two bars, or 25% left, is time to change batteries if possible.

Avoid Editing and Deleting Images with Your Camera

This is known to cause problems, especially with SD cards, probably because they don’t have a controller on board like CF cards.  

Perform Low Level Format Every 3-6 Months

Lexar and Sandisk recommend you use a tool like Lexar Image Rescue to low level format cards a few times a year.  The low level format returns the card to factory condition.  More important, it can identify and block writing to dead areas on the card.  Lexar claims this practice extends the life of memory cards by as much as 25%.

Two Cards Are Better Than One

For important shoots, if your camera supports the setting, consider having your camera write to two cards simultaneously.

Watch for Firmware Updates


Camera and external card reader makers issue firmware updates on occasion. to fix stability problems, so it is a good idea to stay current.